Solution 1: If the device is not functioning properly or to clear
memory, resetit.
- On the operator panel, press the button. (The display will go blank.) Note: It may be necessary to unplug the
power cord if pressing the ON button does not shut off the printer.
- Wait approximately ten seconds and then press the button again.
- Wait until the device has completed its cycling process
before submitting another job request. Note: It may be necessary to
unplug the power cord and retry if the above steps do not clear the error.
Solution 2:
Step 1: Entering Service Mode
- While the printer is OFF, press and hold the Start/Stop button (Resume/Cancel in some other
models).
- While holding the Start/Stop button, press and hold the
POWER button.
- When the POWER LED (green light) lit, release the
Start/Stop button (still holding the POWER button).
- Press the Start/Stop button TWICE (still holding the
POWER button)
- Release the POWER button.
- Wait for the LCD to display “0″ (zero).
Step 2: Using Resetter / Software
- Download Ressetter:
http://www.ziddu.com/download/10241255/ServiceTool_1050.zip.html
- Run “service_tool 1050.exe”.
- Confirm detected USB-port numbers on USB port column.
- Click “Main button” on Clear ink counter section. Make
sure there are papers in the paper feed because the printer will print
after the process is complete.
- Click “platen button” on the “Clear ink counter”
section. The printer will print again.
- Turn off the printer and then turn the printer on. You
printer is ready for use.
