Error E3 is a jam error.
- Power on the printer.
- Open the door for a few seconds and do a print job.
Solution 2:
- Check for any piece of paper in the printer.
- After checking, install the paper and push the
"Black" or "Color" Button.
- Take a sheet of normal paper A4. fold it in two and
still in two.
- Power off the printer.
- Insert the folded paper behind the printer.
- Power on the printer. If there is a foreign object, it
will be extrated by the folded paper.
Solution 4:
- Push the red button during 5 seconds.
- Turn on
the printer.
- The panel
will display error E08, with message “The Ink Absorber is Almost
Full”.
- Download
the Resetter for MP287
- Printer
must be in a state of Service Mode.
- Turn off
the E08 error by pressing the power button.
- Do not
unplug the power cord.
- Press and
Hold the button Stop/Reset followed by pressing the Power button.
- Release
the button Stop/Reset only.
- Press the
button Stop/Reset 6 times, then release both buttons simultaneously.
- The printer MP287 will be in Service Mode.
- LCD Panel
will blank / dark and in your computer will detect new hardware. Ignore
it.
- Exctract
and Run Service Tool for MP287
- Click on
“Play”, then the printer will proceed and will print one page with the
words “D = 000.0″
- Click
“Clear EEPROM”. Then click “EEPROM”, and the printer will print the
results Resetter. Writing one line as follows: “TPage (COPY TTL = 00 000 =
00 000)”.
- Turn off
by pressing the power.
-